General info Therma Control | Applications | Operation | Distributors | Downloads |  

                             

Therma Control as a pumpswitch (Version 2013).

ORDER NOW THE PUMPCONTROLLER

The 2HEAT® Therma Control contributes to an efficient supply of hot water to the manifold, an economical use of the circulation pump and energy savings. When  the boiler don't  supply hot water, the circulation pump is disabled at the preset temperature. When the temperature is above the preset temperature the Therma Control™ ensures that the circulation pump is switched on (the temperature is adjustable). The 2HEAT® Therma Control™ prevents the circulation pump from the heating season due to limescale stuck. During this period, the circulation pump is each day about 30 ~ 60 seconds into service. Application of these 2HEAT® Therma-Control™ results in electricity savings. The savings depends on the capacity of the circulation motor/pump, but the savings are aprox € 75,00 a year.

 

 

 

1)       Insert the white plug of the supplied clip sensor in the 2HEAT Therma Control. On the right side is a recess so that it only fits one way.

2)       Insert 2HEAT Therma Control in the socket.

3)       Plug the pump into the Therma Control.

4)       Attach the clipsensor to the supply pipe from the manifold.

5)       Set the desired temperature.

6)      When the display indicates -: - , the sensor is not connected or is defective!

Therma Control as a thermostat (version 2013).

ORDER NOW THE PUMPCONTROLLER

The 2HEAT® Therma Control™ can easily be used as a thermostat, frost protection function (when the temperature drops below 5 ° C) is automatically activated. The 2HEAT® Therma Control™ can be used to heating, as terrarium heater, electric heaters and radiators, low and high temperature panels, and thermal actuators, switching on based of the set temperature.

 

 

1)    Insert the white plug of the supplied bulb sensor in the 2HEAT Therma Control. On the right side is a recess so that it only fits one way.

2)       Insert 2HEAT Therma Control in the socket.

3)       Plug the heatingelement into the Therma Control.

4)      Mount the bulbsensor where you want to control the temperature.

5)       Set the desired temperature.

6)       When the display indicates -: - , the sensor is not connected or is defective!

Symbols en buttons of the Therma Control.

 

          on / off modus.

     heating mode (frost-protection-function is enabled).

     pumpcontroller mode (pump-protection-function is enabeled).

   set temperature.

     activation frostprotection.

     activation pump protection function.

      display in degrees Celcius.

         display in degrees Fahrenheit.

 

     up button.

        down button.

       function / menu button.

      led indication during activation.

 

 

All symbols, signs and buttons fully displayed;

 

 

Therma Control display readout.

 

Switch on/off;

 

Pumpcontroller function enabled;

 

Heating function enabled;

 

Pump protection function enabled;

 

Frost protection function enabled;

 

The 2HEAT Therma Control ™ is the successor of the ThermoUnit: the two in one plugin controller. By halving the number of push buttons and maintain the functionality the Therma  Controller™ is easy to operate. The Therma Controller™  can be used as a example for a conventional heating pump switch.

 

This development was created by 2HEAT: Heating in Optima Forma.

 

                 The 2HEAT ThermaControl™ is only supplied by distributors in the Netherlands, Belgium and Germany!